Lagmaster Pole
The Lagmaster Pole is the electrician’s pole tool. The unique plug-in heads make it the most efficient tool of its kind. It increases safety by keeping your men on the floor. Use it to install ceiling wire, jack chain, threaded rod, smooth rod and overhead screw installation. Power the pole with any 3/8″ or 1/2″ batter operated or corded drill.
The lagmaster is the electrician’s only multipurpose tool for hanging:
With Inter-changable Heads!
Choose from five different adjustable length models:
- LM-6 Double 3′ (11′ ceilings)
- LM-12 Double 6′ (18′ ceilings)
- LMG-12 Triple 4′ (18′ ceilings)
- LM-18 Triple 6′ (24′ ceilings)
- LM-24 Triple 8′ (30′ ceilings)
Lagmaster Plus Plugs:
Hang it up – the Lagmaster Plus Wire Plug:
The Lagmaster Plus wire plug hangs 12 or 9 gauge wire as well as jack chain.. No need for ladders, scaffolding or scissor lifts.
Note: Pre-wrapped Wire on eye lag screws require a special plug (pre-wrapped plug).
Drive it home – Lagmaster Plus Socket Plugs:
Install pre-cut threaded rod from the floor! Works with 3/8″ or 1/4″ threaded rod up to 10′ long. Gets into tight spaces, vaulted ceilings, above stairwells or through ceiling grid easily.
The open-end socket plug-in heads work with Sammy Super Screws and HangerMate screws. Special twist out feature prevents over torquing and strip-out, even when installing from the floor.
Consult the screw manufacturer’s literature for load specs and approvals on the screws.
The base is the sockets for HangMate 3/8″ rod screws. The 3/8″ socket plug-in works with HangerMate 1/4″ rod screws. The 5/8″ socket plug-in works with Sammy Super Screws.
Overhead Screw Applications – the Lagmaster Plus 1/4″ Hex Plug:
Turn your pole tool into a very long screwdriver. This Lagmaster’s plug works with any 1/4″ hex driver.
Install smooth rod with Minerallac or Caddy Spring Clip assembly and screw.
Hang it up – the Lagmaster Plus Stud Plugs:
It has plug-in adapters for Ramset’s J-Master tool, Caddy’s VAFT tool and Minerallac’s tool. Simply pug in the stud, attach the tool and adjust the telescoping pole to the correct length to install pre-wrapped wire and clip assemblies to open web bar joists and Z-purlin clips.
Fire it off – more Lagmaster Plus Stud Plugs:
Lagmaster Plus plug-in studs make your lagmaster an adjustable pole for Powder Actuated tools. Great for installing pre-wrapped wire and angle clip assemblies, EMT clips and smooth rod and spring clip assemblies (Flash Fasteners).
SAVE TIME ON THE JOB AND DRASTICALLY REDUCE USE OF LADDERS & SCISSOR LIFTS! CUT LABOR AND RENTAL COSTS!
4121 Guardian St.
Simi Valley, CA 93063
Toll free: (800) 544-8706
Phone: (805) 583-9911
Fax: (805) 583-9946
Email: info@docsindustries.com